LT 2000

Space saving plastic surface treater for three dimensional parts, both oriented and non oriented.

The LT 2000 is Lectro Engineering’s latest addition to four plus decades of plastic surface treating equipment. It is smaller than and just as powerful as a standard LectroTreat with the same tunnel dimensions. It can be used in bulk or in-line applications. The unit has all the benefits of our standard open air plasma discharge system at a fraction of the cost.

Compare the LT 2000 with 3D Corona

LT 2000 Features & Benefits

Surface Treatment Levels >70 dynes/cm over the entire outside of three dimensional plastic partsAllows the decoration/adhesion on plastic parts without the use of costly primers or chemical wipes
Open Atmosphere PlasmaContinual process, no vacuum required, higher production rates
VersatilityNo set-up required for different shapes resulting in labor and production savings
No HeatZero scrap due to heat warping, surface crazing, stress relieving and paneling. Maintains the surface integrity of your plastic parts. Thin walling of parts made possible resulting in material savings
Safe EquipmentLower insurance premiums, no open flames
Efficient OperationLow cost power construction
Low Frequency 50-60HZNo interference with Electronic/PLC/Computers controls
PLC ControlsReliable and repeatable production rates, allows interface with entire production line
Cold Plasma360 degree uniform surface treatment guaranteed

LT 2000 Specifications

Input VoltageStandard 240 volt, 3 phase Any voltage can be accommodated
Frequency50-60HZ
Total Electrical Load5 KVA on standard units
CertificationUL, CSA or CE components
Equipment Dimensions38″ wide x 72″ long x 60″ height
12″ conveyor extension each end
Conveyor Heights37″ above the floor
Complete SystemsStandard unit includes surface treating, conveyor and exhaust systems.
Custom DesignAvailable upon request

Specifications are subject to change without notice. Guards are supplied and must be in place before operation. All sales are subject to our prevailing terms and conditions of sale. Other options available upon request.

Back to top of page