LT 2012

LT 2012 takes up 66% less floor space than the standard 12” Bulk LectroTreats

The LT 2012, with it’s 12” tunnel size, is a direct replacement for the most popular LectroTreat of all time. The LT 2012 takes up to 66% less floor space than the standard 12″ bulk LectroTreat. Even with its smaller foot print, the LT 2012 can achieve higher line speeds than the standard LectroTreats.

The LectroTreat operates on a HV capacitor system creating an oxidized cold plasma inside the plasma tunnel at atmospheric pressure. All parts pass through the tunnel on a continuous conveyor system. The LT 2012 reaches a higher level of energy by supplying what is referred to as a directional plasma in air. This directional plasma allows any part to be completely treated.

LT 2012 Features & Benefits

Download Product Sheet

Wet Surface Treatment Levels >70 dynes/cm2 over the entire outside of three dimensional plastic parts.	Allows the decoration/adhesion on plastic parts without the use of costly primers or chemical wipes
Open Atmosphere Plasma	Continual process, no vacuum required, higher production rates
Versatility	No set-up required for different shapes resulting in labor and production savings
No Heat	Zero scrap due to heat warping, surface crazing, stress relieving and paneling. Maintains the surface integrity of your plastic parts. Thin walling of parts made possible resulting in material savings
Safe Equipment	Lower insurance premiums, no open flames
Efficient Operation	Low cost power construction
Low Frequency 50-60HZ	No interference with Electronic/PLC/Computers controls
PLC Controls	Reliable and repeatable production rates, allows interface with entire production line
Cold Plasma	360 degree uniform surface treatment guaranteed

LT 2012 Specifications

Input Voltage	Standard 240 volt, 3 phase Any voltage can be accommodated
Frequency	50-60HZ
Total Electrical Load	5 KVA on standard units
Certification	UL, CSA or CE components
Equipment Dimensions	46″ wide x 78″ long x 75″ height 18″ conveyor extension each end
Conveyor Heights	43.5″ above the floor
System	Comes completely assembled. Ready to use, No set-up!
Custom Design	Available upon request

Specifications are subject to change without notice. Guards are supplied and must be in place before operation. All sales are subject to our prevailing terms and conditions of sale. Other options available upon request.